OCTAVER OC D2 VST DEMO FULL

This plug-in has the capability to easily reproduce this mod, by adjusting only a few parameters.

Many users of the Boss OC-2 pedal seek to add a hardware modification that disables the output filter and dynamics sections in order to produce a more synth-like tone.'Listen' radio buttons allow the user to tap the audio at any stage to hear what's happening behind the scenes, and bypass certain sections if desired.Includes a 'tuning' control to affect the zoom ratio. A scope displays both the key signal and the output signal, so the use can see how the plug-in is operating, and help identify what controls need to be adjusted in order to track more accurately or produce the intended sound.A DC-offset switch corrects the input signal to improve tracking on rectified or offset signals.Since the peaks/crests of the sine(ish) waves of the filtered key signal slow their rate of change at the point where they begin to change direction, crossing at this point instead of at the quick zero-crossing of the original waveform results in smoother transitions with less harmonics. The signal is then flipped in polarity when the peaks hit zero. Here, the key signal is DC-offset so that negative peaks sit at zero amplitude. A different version of a flipper circuit is used for this mode. Mode B is a more complex circuit, and a more accurate simulation of the original Boss OC-2 pedal. It provides a Poly mode that offers numerous enhancements for extended range playing as well as a Vintage mode for a recreation of the Boss OC-2. This abrupt change in direction causes additional harmonics, and results in a brassy tone (although can be filtered out). The Boss OC-5 is one of the most popular octave pedals in the market.This pedal picks up right where the Boss OC 3 Dual Super Octave pedal left off.

Mode A (old version) flips the polarity of the key signal directly at the positive zero-crossings.

Polarity Multiplier has two modes: A and B.

OCTAVER OC D2 VST DEMO FULL

In phase-multiplier mode, the full dynamics of the key signal are retained. In additive mode, dynamics for the oscillators can be controlled either by a noise gate or an envelope follower, both keyed off the input signal.The additive mode simply mixes in the octave down signals (via user-adjustable levels and wet/dry balance), whereas the phase-multiplier mode flips the phase of the key signal, following the state of the selected oscillator. Option for two modes of operation: additive oscillators or phase-multiplier.Both on oscillator outputs (changes tone from full square wave to pure sine, or anywhere in between) as well as on the detection circuit (which can fine-tune the accuracy of the octave-divider's tracking).Controls to all the typically fixed values for low-pass filters.It's unique from the Boss and other pedals, and other octaver plug-ins, in that it offers: It's based on the popular Boss OC-2 pedal, but with many more features and customizability far beyond what other octavers offer. OC-D2 is an octaver plug-in that generates a signal one and/or two octaves below the original.

Octaver oc d2 vst demo